Don Colley

@simonhoult

Yes I have and each time I use the printer it seems to get worse. I am printing at the moment so I looked and there are patches in area’s that I have not printed in. The printer is also new and I have not noticed it on my other one but I can’t check as it is being refurbished.

@generalskruf1

Providing you use a good quality filament of the type Cel provide you should have no problems, all you need is a rotating carrier for the spool, I made mine from two disks of plywood and a lazy susan bearing

from e-bay but there are lots of variations on Thingiverse.

Good luck with your Robox I have had mine for over two years…[Read more]

@simonhoult

Found the one I used but I don’t know if you would class it as good, but it worked for me. I had to fiddle with the settings as it printed but can’t remember the final settings.

The main problem was getting it out of the printer, don’t leave it in after print is finished.

@simonhoult

I have used it successfully but can’t find where it is stored, I had to play about with the speed and flow rate so it took a few trial runs.

The main trouble was getting the filament out after printing, do it strait away!

@click

@bhudson

Thanks for the information.

@click

Thanks, that is what I thought but wondered if two printers using the same program would cause problems.

@teleporteur

You could try Meshmixer. It has worked for me.

@bhudson

Thanks that is what I have been doing, I just wondered if there was a more exact way, obviously not.

@gid

If I had to go to extent that you suggest I don’t think I would bother with 3d printing at all.

@gid

This is not meant to be more than an hours of protection not days,over night for instance. It takes longer some times to set up dual filament printing than the print itself.

@pete

Yes there is space where a silica gel would fit. A small perforated cage could fit in one of the corners, quite a simple addition.

@pelgrim

It does not open, it has a firm sliding fit into the existing aperture.

Sorry no picture

@ultimatum

I have used Robox shipping on two occations and the service was excellent.

@pete

Thanks Pete, just the answer I hoped for.

@pete

Post warranty.

1/ Will we be able to use support?

2/ Will we be able to get repairs done?

3/ Will we be able to obtain replacement parts?

If so will you be posting a list of costs?