Don Colley

Clicky

I have attached the knife holder file, it is in thingiverse but I am not very good sorting it out

I am running a production model and have been printing on it since 25th Oct with only one problem, filament feed, fixed in short time by support. I use Tinkercad to design most of my things and Meshmixer to check before printing. The knife holeder designed with Tinkercad as was the yellow filament guide in the background.

Sorry to repeat myself,if you try printing a large area just two or three layers thick after cleaning bed, leave to cool before removing it then don’t clean the bed just scrape the edge of a credit card over it to remove any small bits left, I find the prints stick so well you have to wait untill the bed is nearly cold before the object comes…[Read more]

I only use ABS, don’t clean the bed, hardly ever get blobs where did I go wrong oh and don’t fiddle with the settings.

ABS I have several reels from a now defunked printer I am using up.

I dont clean my print bed unless its got bits on it then only with the edge of a credit card ABS sticks no trouble always best where it has printed before. only checked nozzle height twice since I received it.

Had filament fead problem ticket replied to and trouble fixed in a few days, very happy!!

Ordered from Portishead shop by phone

I rang the shop last week and ordered ABS and received it the next day.

<span style=”font-weight: 200; color: #d6d6d6;”>@dmullerdesign</span>

This might be wrong in your case but when you click on + at the top next to the small blue status simble a number comes up this is just a ref for the item you are about to load, to load you file press the + circle at the bottom and your file will appear for you to chose your…[Read more]

If you intend to use this directly onto the Robox hub as it appears from the drawing how are you going to insert an EPROM to make it work?

Are you using a powered USB hub if not you could have problems. I believe I have seen it mentioned.

I just paused and ejected the filament that was running very low and then fed in the new filament, a bit of a panic at the time. Pete’s article was in the back of my mind so I new it could be done and the change over went very smoothly as you can see from the result.

Normal quality, never tried draft. Pete did an article on two colour printing I think you can find it under “News”

sorry senior moment better luck this time I hope

I was not going to update it but you can load the stl file into tinkercad quite easily and work on it with no trouble

@jack-strong

I just leave well alone, normal quality, 3 brims and 50% infill and push the button. I bought it to plug and play and that’s what I do I dont know enough to fiddle with the other settings and I have a stack of ABS from a friends defunced printer so that’s what I use, I print at 102% to allow for shrinkage and it seems to work for…[Read more]

I have been using my Robox for a few days now and thought that I should show a few of my prints. They are all done in normal mode and with ABS I am very pleased with the results with no adjustments, I find that if I need to be accurate with size I print at 102% the Dremel attachment screwed strait on and is a good tight fit.The knife block was…[Read more]