Topic: Printing using 80% Metal infused or carbon filament?

RoboxDual › Forums › Materials › Printing using 80% Metal infused or carbon filament?

This topic contains 14 replies, has 7 voices, and was last updated by Profile photo of BHudson BHudson 3 weeks ago.

Viewing 3 posts - 13 through 15 (of 15 total)
1 2
  • Author
    Posts
  • 02/02/2017 at 10:51 am #36632

    Andrius @murloc992
    My Robox is a Blue Commercial Version
    Lithuania

    So nobody had any experience with Taulman3D T-Glase?

    Also another small question: what is the black version extruder gear material? Is it plastic or metal?

    02/02/2017 at 11:21 am #36639
    Profile photo of click
    click @click
    My Robox is a Green Kickstarter Limited Edition

    @pete what about AM profile(s) for ninjaflex? Not that I have issue with one you shared here, but why not releasing it even though there won’t be ninjaflex on the smartreel?

    02/02/2017 at 1:49 pm #36644
    Profile photo of BHudson
    BHudson @bhudson
    I have several Robox units Kickstarter and Commercial
    Arizona, USA

    @click If CEL releases a profile it may imply support for that material from CEL so they are careful about it.

    I operate two Betas and one Production Robox.
    I am the US/Canada Technical Support engineer for the Robox.
    See my 3D Hub site at https://www.3dhubs.com/phoenix/hubs/ben

  • Author
    Posts
Viewing 3 posts - 13 through 15 (of 15 total)
1 2

You must be logged in to reply to this topic.