Martin Sloth Hansen
-
Martin Sloth Hansen replied to the topic Community testing: Speeding up prints in the forum Announcements and settings experiments 1 month ago
@microcan
thx buddy -
Martin Sloth Hansen replied to the topic Community testing: Speeding up prints in the forum Announcements and settings experiments 1 month ago
how do i speed up prints in automaker 3.0?
-
Martin Sloth Hansen replied to the topic [resolved] latest v3 automaker software killed gopro support? in the forum Technical Support 1 month ago
it would be cool if the system could be customized with the lighting options
example is that i could set it to turn off all lighting before layer end, it takes the picture and turns on the lights again -
Martin Sloth Hansen replied to the topic [resolved] latest v3 automaker software killed gopro support? in the forum Technical Support 1 month ago
it would be cool if the system could be customized with the lighting options
example is that i could set it to turn off all lighting before layer end and it takes the picture -
Martin Sloth Hansen replied to the topic Save pangolins in the forum Show us your bits! 2 months, 3 weeks ago
i plan to make three of them
one of each of the following sizes
50%
100%
200% -
Martin Sloth Hansen replied to the topic Save pangolins in the forum Show us your bits! 2 months, 3 weeks ago
if u rotate the model 34 degrees it will fit within the build volume
-
Martin Sloth Hansen changed their profile picture 3 months, 1 week ago
-
Martin Sloth Hansen started the topic abs clogged fine nozzle first now both in the forum Technical Support 3 months, 1 week ago
Hi guys
i a little problem with my robox
i had my Robox run all morning to print something
when i finally had time to look at it the fine nozzle was clogged
first thing i did was running the purge command 6 times
0.3mm nozzle only left a small sting
0.8mm nozzle printed fine
then i tried to do a manual purge,
could not push the filament out
ive…[Read more] -
Martin Sloth Hansen replied to the topic Car interior accessories in the forum Show us your bits! 3 months, 1 week ago
looks great buddy
-
Martin Sloth Hansen became a registered member 3 months, 1 week ago
