Save pangolins

[Microcan @microcan My Robox is a Blue Commercial Version]

I saw this model and I could not resist it. It look so cool.

It is designed for 0.2 mm layer height. It doesn’t fit inside the robox so I printed it at 50% and 0.1 mm layer height.

http://www.thingiverse.com/thing:2064359

Attachments:

1. 

   IMG_0263.jpg
   

[Martin Sloth Hansen @storm4710 Danmark]

if u rotate the model 34 degrees it will fit within the build volume

 

[Henry @henry My Robox is a Blue Commercial Version Washington State USA]

It also prints in 4 sections with the 4 legs. Fits nicely on the build plate. I printed one and it looks good.

 

[Martin Sloth Hansen @storm4710 Danmark]

i plan to make three of them
one of each of the following sizes
50%
100%
200%

[Microcan @microcan My Robox is a Blue Commercial Version]

@storm4710 thanks I also did 50% because of the print time and the amount of filament. I printed the stand as well so now it is complete.

 

Attachments:

1. 

   IMG_0264.jpg
   

[Ian @sonicthehedgehog My Robox is a Green Kickstarter Early Bird]

Funnily enough I also did one of those the other week.
The 4-part version works just fine, and after a bit of persuasion to deal with bed-spread it’s appropriately bendy.

There’s been a lot of squeeing…

• This reply was modified 5 months, 1 week ago by  Ian. Reason: File size limits for attachments

Attachments:

1. 

   IMG_20170316_104316631.jpg
   

2. 

   IMG_20170316_104334793.jpg
   

[Microcan @microcan My Robox is a Blue Commercial Version]

Nice the big brother works as well.

[Author]

Posts