This topic contains 4 replies, has 3 voices, and was last updated by 
StreatSi 1 year, 9 months ago.
-
Posts
-
just tried installing the new automaker that has been released but get an error message straight away as attached image - anyone else had anyluck installing - using win7
and then got the below firmware error as well.
@streatsi, software has installed ok on my win7 lappy, will be trying the firmware later. Have you tried turning it off and on again 😉
may be worth uninstalling the old version fully, deleting all remaining folders and running a fresh install too, if you haven’t already?
- Oh, it’s in the README 🙂
version 1.00.14
Updates to default print profiles and macros.
Fixed issue in post-processor affecting very small extrusions where nozzle did not always close before travel.
Reduced settings screen bed rotation load on CPU.
Temperature graph is now visible during purge.
Minor purge handling modifications.
Version and date is written to post-processed gcode files.
Update to version 684 firmware.complete uninstall done and new automaker & firmware nicely installed and first print underway.
wonder when teh new x-y test is going to be incorporated as certainly in need of that for my calibration
You must be logged in to reply to this topic.
