Topic: Automaker button

RoboxPro › Forums › Software › Automaker button

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Chris White Chris White 1 year ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 11, 2017 at 6:58 pm #36861
    Profile photo of Shaun
    Shaun @saiken
    I have several commercial Robox units
    BC, Canada

    My “Add Model” button doesn’t do anything in AM 2.01.04 (Win 64 bit). I’m adding models by dragging them from an Explorer window. Restarting does nothing to remedy the problem.

    I suspect that I’ll eventually get tired of this and reinstall. Just so you know it can happen.

    February 11, 2017 at 8:16 pm #36863
    Profile photo of BHudson
    BHudson @bhudson
    I have both RoboxDual and other Robox versions
    Arizona, USA

    @saiken This is a known issue when the last used location is no longer available - a network drive that has been disconnected or a USB drive that has been removed. Try a clean install and it should solve the issue.

    I operate two Betas and four Production Robox.
    I am the US/Canada Technical Support engineer for the Robox.
    See my 3D Hub site at https://www.3dhubs.com/phoenix/hubs/ben

    February 11, 2017 at 8:24 pm #36864
    Profile photo of Chris White
    Chris White @chrisyt

    @saiken see this post ‘Add Model Not Working’

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.