Mika

It’s damn slow, but finally got some decent yellow NinjaFlex prints out. 100 % cooling fan and enough temperature. Pink is PLA and green is the real Lego.

ps. Seems this video has almost all info needed, but missing only 100 % cooling part and bed without heating: https://youtu.be/fTJz6vMvtJ8

@simonhoult How would you compare PolyFlex and Ninjaflex / Semiflex? Is PolyFlex as soft as Ninjaflex?

I’m also thinking Robox DM head vs. totally new open source 3D printer. If there would be a good future proof roadmap from Cell the choice would easier.

Seems we have better (more thick printing) paper (lots of forest and wood) here in Finland. 🙂

3D printing quality improved a lot after re-calibrating z-axis with more thin piece of paper (receipt of beer bought from local grocery shop). I tried to use my normal 80 g/m^2 printer paper for the calibration earlier.

Documentation could be improved…[Read more]

Support from S3D would be awesome. 🙂

I haven’t got that good results (attached test part is the best I have got). Printing quality kind of depends from a day. Some day better and some day worse prints. Lower parts can print more easily. Outer perimeters does not stick well if not enough temperature. Only used smaller nozzle. Tried bigger nozzle but seems it was not able to output…[Read more]

I have played with yellow NinjaFlex for over a week now and tried to find good settings for it, but it seems quite challenging. Started from the starter profile. Is there any step by step guide in which order all the parameters should be tuned? That kind of instruction could save a lot of time from beginners to 3D printing like me. Also some…[Read more]