Topic: reprogramme reel

This topic contains 8 replies, has 3 voices, and was last updated by Don Colley 12 hours, 47 minutes ago.

Viewing 9 posts - 1 through 9 (of 9 total)

Author

Posts
03/04/2015 at 9:45 am #17233

Don Colley @doncolley

How can I reprogramme an empty Cel reel from one material to another.

03/04/2015 at 5:29 pm #17242

BHudson @bhudson

My Robox is a Green Kickstarter Beta

@doncolley In AutoMaker, click the “gear” symbol in the upper right hand corner. Click “Environment” and check the “Advanced Mode” box. Read and accept the warranty disclaimer.

Click the “Back” arrow and click the three white dots to open the advanced settings pane. Click the “Reel” tab.

You have two choices at this point. If you have a filament profile already made, you can simply select it from the dropdown menu under “Write a known filament to the reel” and then click “Program Reel”. Otherwise, enter the filament profile data into the boxes and click “Write to reel”.

I am not affiliated with CEL; I operate two Betas and one Production Robox.

04/04/2015 at 8:59 am #17244

Don Colley @doncolley

@bhudson

Thank you for your reply, before I press the advanced button, I am doing a prototype for a friend and the only material that seems to fit the bill is nylon, are there any known problems with tauman bridge apart from sticking to the bed after printing?

Also did you manage to sort out the problem with XT and the blown O rings?

04/04/2015 at 10:40 am #17245

poju @poju

My Robox is a Blue Commercial Version

“If you have a filament profile already made, you can simply select it from the dropdown menu under “Write a known filament to the reel” and then click “Program Reel”

I think you dont need to unlock advanced mode for this, cant verify at the moment tho.

04/04/2015 at 12:13 pm #17246

poju @poju

My Robox is a Blue Commercial Version

Yep, just tested, if u have profile ready you can write it to reel without advanced mode.

04/04/2015 at 1:48 pm #17247

Don Colley @doncolley

@poju

No I don’t have the profile

04/04/2015 at 2:46 pm #17249

poju @poju

My Robox is a Blue Commercial Version

Just a tought, if you want to fool system, install previous version and make profile there well improvements in latest version are minor so one can stay in previous version

04/04/2015 at 5:30 pm #17253
BHudson @bhudson

My Robox is a Green Kickstarter Beta
@doncolley CEL says that they think the _XT and blown o-rings is not the material but the o-rings being defective. My new heads have been printing just fine.

I don’t know of any problems with Bridge. The last several prints I have made with it haven’t had good interlayer strength, but I am not sure if that is the material or my settings.
- This reply was modified 12 hours, 58 minutes ago by BHudson.
I am not affiliated with CEL; I operate two Betas and one Production Robox.
04/04/2015 at 5:45 pm #17255

Don Colley @doncolley

Thanks to both of you for your help, I did try to go back to previous AM but for some reason it would not work. I will have to try another way as I am trying to make a hamburger holder for a disabled young man so really it should be in nylon I think.
Author

Posts