Topic: Manuel control don't work

Home › Forums › Software › Manuel control don't work

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of BHudson BHudson 6 days, 7 hours ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 03/08/2016 at 7:27 am #31903

    Alexandre Contat @calexfr
    My Robox is a Blue Commercial Version

    I have this problem with AM 2.01.02, the manuel control to move the head on X Y Z or load filament don’t react to my Gcode command, and no more to the interface buttons.

    Attachments:
    You must be logged in to view attached files.

    Regards

    Alex from France
    diStudio3D

    03/08/2016 at 7:31 am #31905

    Alexandre Contat @calexfr
    My Robox is a Blue Commercial Version

    Now it’s working, I do nothing and it’s working…

    Regards

    Alex from France
    diStudio3D

    03/08/2016 at 12:46 pm #31919
    Profile photo of StreatSi
    StreatSi @streatsi

    i did have teh same proplem yesterday actually. it worked for moving the head up & down, but not left to right or forwards & backwards

    03/08/2016 at 3:05 pm #31924
    Profile photo of BHudson
    BHudson @bhudson
    I have several Robox units Kickstarter and Commercial
    Arizona, USA

    @streatsi @calexfr You need to run a Home before you can manually move the position of the print head.

    Please note that Advanced Mode may limit your warranty coverage.

    I operate two Betas and one Production Robox.
    See my 3D Hub site at https://www.3dhubs.com/phoenix/hubs/ben

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.