This topic contains 3 replies, has 3 voices, and was last updated by 
Pete 1 week ago.
-
Posts
-
Just tried to do a purge on a Kickstarter with a new extruder & Bowden tube replacement, and the purge is not shifting the build plate in the Y direction, as the offset is too small between nozzle purges.
No problem with the Y test, getting full movement, and no strange noises from the motion backwards and forwards. Is this a macro error or firmware update?
Updated graphic needed?
Looks like it is a change in the macro, as there’s only 4mm offset in the Y now rather than 15mm…changelog anybody? 🙂
- This topic was modified 1 week, 1 day ago by Mike. Reason: Update
The macro has been changed and the purge lines are now closer together to allow the purge to be lifted from the build plate in one piece.
- This reply was modified 1 week ago by Lee Bowman.
- This reply was modified 1 week ago by Lee Bowman.
Robox Support Engineer
@leecel Thanks for that, but I did spot the changes afterwards to the macro gcode & updated the post, however it just caught me out initially, as I hadn’t seen this noted anywhere in a changelog. The graphic still shows the old method, so that’ll need updating as well.
ill submit the graphic as a change for next release.
For official support please visit www.cel-robox.com/support/ and create a ticket
You must be logged in to reply to this topic.
