Bypass cooling when print done (for successive prints)

[Jared Reabow @jaredareabow oxford]

Is there a way to bypass the cooling procedure when printing multiple prints, it seriously slows down workflow waiting for thing printer to cool, just to warm up again.
Thanks.

[Mike @17bt CHORLEY, Lancashire]

@jaredreabow

How about switch it off and on, assuming you are doing a follow on print, and put up with the error message re hot printhead. 🙂

 

[Jared Reabow @jaredareabow oxford]

Unfortunately, with the robox pro:
A: I don’t want to wait for the PI to boot before I can use it.
B: I don’t want the PI to corrupt from unexpected shutdowns.
C: This is a very dodgy solution to something that should be a very simple software fix.

But thanks, I know about this option, just would rather not.

[BHudson @bhudson I have both RoboxDual and other Robox versions Arizona, USA]

@jaredareabow Can you not just turn off the safety features? Preferences - Printing - Safety Features

This turns off the post-print cooldown and also the door safety on the original Robox, I assume it would for the Pro also, though I don’t have one yet to test.

I operate two Betas and four Production Robox.
I am the US/Canada Technical Support engineer for the Robox.
www.hudsondesignlabs.com

[Jared Reabow @jaredareabow oxford]

Thanks

[Author]

Posts