This topic contains 2 replies, has 3 voices, and was last updated by 
BHudson 4 days, 16 hours ago.
-
Posts
-
I am screwed. I really nee help. Got the dreaded B axis stuck error. Usually when I get this I can just turn off and turn back on and it is gone. This time not so lucky. When I try to do anything it hits the error. I can not heat up the temp. filament can move freely. WHen I manually turn on light it flickered at first now turns on and off, the fan will not turn on or off and sometimes the fan button turns on and off the light! Easy fix I hope? Or Christmas isn’t coming this year
I can pay pal a small amount of money if you can fix my issue 20$?
You can read this thread:
http://www.cel-robox.com/forums/topic/b-axis-stuck-error-2/
Hope it helps.
Magelan
@makerjosh It sounds to me like your print head is loose or the wiring is loose. There are four places you can check:
1. The head attachment screw on the back. Make sure the Robox is turned off. Push the head back into the head carrier and tighten the screw on the back to make sure it is retained.
2. On the back of the head carrier are two cables: a 2-wire power cable and a ribbon cable. I am guessing the two-wire cable may not be seated properly at either the head carrier or the Robox wall. Check these three places and make sure the cables are seated.
If you need more help, I am happy to provide it, either by Skype or by phone. If you want to go to email, mine is ben at bahudson dot com
You must be logged in to reply to this topic.