This topic contains 2 replies, has 3 voices, and was last updated by 
David 2 weeks, 6 days ago.
-
Posts
-
A new work-in-progress project of an articulated action man (for eventual stop motion animation). There are twenty-nine files but containing a lot more pieces. This is the head which I had tried to print with the neck sections at the same session, but after a successful start the neck sections slid off and I had to restart. That’s not exactly a problem since the time required for printing several sections in one go really takes too long for one session - I have to let it run overnight. The guy who designed this figure is a professional model-maker and has produced the files so that they all start with a flat side. Thus support struts are not needed, each part is in two sections that you stick together afterwards. When fully assembled the figure will be 18 inches tall and have 70 individual articulated joints.
Wow, nice one!
That roll of green ABS is still going strong then!
You must be logged in to reply to this topic.