Claus Petersson

Hi

I have a dual head, 2×0,3 mm.

I I would like to set the temp. To a specific head, can I do that via the console in code? And how do I direct the command to either head.

I think that the T0 ist the right one of the the heads if You front the printer and it is fed with extruder/filler no 2. Somewhat confusing!

brg

Claus

Hi

I am trying to get about 4 mm font (Arial and Tahoma both normal and bold) but the print is not so good. As I go bigger the print is better though it is not perfect.

Is there any way to print more nicely?

Should I set down the Printing speed? Will it be better if I set the quality to very fine?

Should I Think about something when working…[Read more]

Hi

I am trying to get about 4 mm font (Arial and Tahoma both normal and bold) but the print is not so good. As I go bigger the print is better though it is not perfect.

Is there any way to print more nicely?

Should I set down the Printing speed? Will it be better if I set the quality to very fine?

Should I Think about something when working…[Read more]

Hi

I am trying to get about 4 mm font (Arial and Tahoma both normal and bold) but the print is not so good. As I go bigger the print is better though it is not perfect.

Is there any way to print more nicely?

Should I set down the Printing speed? Will it be better if I set the quality to very fine?

Should I Think about something when working…[Read more]

Hi.

I have seen that the basplate can move in x-direction and will give a disrupted Printing that of fase.

I have printed a small detalj to fix the plate in x-direction. Y-direction will be dealt with at the same time.

Attached is the detalj in AM

Best regards

Claus

Hi.

I have seen that the basplate can move in x-direction and will give a disrupted Printing that of fase.

I have printed a small detalj to fix the plate in x-direction. Y-direction will be dealt with at the same time.

Attached is the detalj in AM

Best regards

Claus

Hi.

I have seen that the basplate can move in x-direction and will give a disrupted Printing that of fase.

I have printed a small detalj to fix the plate in x-direction. Y-direction will be dealt with at the same time.

Attached is the detalj in AM

Best regards

Claus

After about 25 hours of use, I see that there is smaller amounts of plastic (PLA) pouring out on the side. It´s not as much yet to mess the Printing but if it gets to muck it will. What shall I do? Is it wise to detach the head or not? Can it be cleaned or shal I just let it be? Maybe setting the temp and try to peel the plastic away?

Brg

Claus

Hi.

Why is the manual not updated to the version of AM 3.00?

Brg

Claus

Hi.

In the manual for AM it says that I am able to change the profile and there are som pattern to choose. But fill pattern does only show Linear and it is not possible to change. And support pattern have only two kind of pattern but the manual shows four different patterns.

Will this pattern be enabled in future updates of AM?