David_Wilford
-
David_Wilford replied to the topic Sending data to printer timing out using Root in the forum Software 1 month ago
I have the same problem with more complex designs using Root and ethernet. It is fine with simple designs, so WiFi may not be the root cause (no pun intended) of the problem.
I have resorted back to using a laptop and USB until an update is published.
The Raspberry also goes into sleep during a print and so you have to disconnect then re-connect…[Read more]
-
David_Wilford‘s profile was updated 1 month, 3 weeks ago
-
David_Wilford replied to the topic Screw in back of head carrier in the forum Technical Support 1 month, 3 weeks ago
Hi,
A fellow Robox friend of mine had a couple of Headlock screws fail on him so his solution was to use an M4 stud that is semi-permanently attached to the head and an M4 nyloc nut that is a push fit into a redesigned (3D printed of course) wheel. The nyloc nut ensures that the wheel will not work loose. The stud doesn’t unscrew as he applied a…[Read more]
-
David_Wilford started the topic Firmware for 2.01.03 when back converting from 2.01.04 on Mac? in the forum AutoMaker 2.01.04 Bug Reporting 5 months, 1 week ago
I have found a number of bugs with 2.01.04 on a Mac running El Capitan or Mountain Lion (to the point where it is unusable) so I have back converted to 2.01.03 (this version locks up if the Mac goes to sleep but i can cope with that). Anyone know how I “back convert” the firmware or if I even need to do so? Thanks.
-
David_Wilford became a registered member 1 year, 1 month ago
