Andy Stanford-Clark

Filament “nudge” arrows don’t work properly

In the status display of Automaker (3.00.00), where there are some arrows to move the head around and move the filament in and out, the arrows are quite hard to see on the spools of filament, and the active areas on them are very very small - For example the “in” arrow head is only active right on the…[Read more]

AutoMaker (3.00.00) isn’t very good at remembering a non-smartreel filament selection.

If you have a non-smartreel filament loaded, and choose the type and colour from the selection box on the left side of the main screen (where the filaments are shown), then it seems to forget that and go back to “unknown” rather too often.

This is when using…[Read more]

Any chance you could give us some technical info about the API your code is actually invoking on the GoPro, please? I don’t have a GoPro, but have a cunning idea for a Raspberry Pi and some Node-RED programming 😉

Looks like if there’s an existing project tab open (it seems to pick up the tabs from the old AutoMaker), then when you click the Add Model button, it imports the STL file into the last opened tab, but doesn’t create a new tab, even though you click “+”.

If there are no tabs open, and you click “+”, there’s nothing, then you click -> to layout,…[Read more]

Yes, same here - the little progress bar goes across, but it doesn’t open a project tab, and nothing happens.

AutoMaker on Ubuntu