Updated to AutoMaker 1.01.03 with firmware r721 - re-calibration required?

[chanyufei @chanyufei My Robox is a Blue Commercial Version]

Hi,

I just upgraded the AutoMaker and firmware. Do I need to do all the calibrations?

Thanks!

[Aimdy @mistsoul My Robox is a Blue Commercial Version]

@chanyufei although I have not printed with the new software yet, I would think no because the items that were indicated as updated in the release note if I recall correctly were not related to calibration, however do double check the release note. Also it never hurts to redo the calibration every so often.

Moh

[chanyufei @chanyufei My Robox is a Blue Commercial Version]

@mistsoul Thank you for the suggestions! I totally agree with you

[Simon Williams @ultim8fury My Robox is a Blue Commercial Version]

since the update I’ve had to redo the nozzle height and the needle valve one. Couldn’t say whether it’s just new printer bedding in or update related but like others have said. Doesn’t hurt to rerun the calibration every now and then.

[chanyufei @chanyufei My Robox is a Blue Commercial Version]

Thanks @ultim8fury !

I’m planning to re-do the calibration this week as well

[Author]

Posts