This topic contains 1 reply, has 2 voices, and was last updated by 
Pete 5 days, 2 hours ago.
-
Posts
-
This is my growing collection of 3D printed classic sculptures. They sit at bed level in my bedroom so that I can admire them from a resting position. The split in the sculpture on the right back is not a fault. I printed it in two halves and should have sanded down the joining surfaces before gluing - the surface warped very slightly. The sculpture on the left is called “The Dying Gaul” and needed a turn of 10 degrees, then fitted across the whole of the print bed. The sculpture in middle front is a boy playing marbles and really came out well.
These have been printed in white ColorFabb nGen.
this is too much culture for a Monday morning 🙂
You must be logged in to reply to this topic.
