This topic contains 2 replies, has 3 voices, and was last updated by 
Jack 1 month ago.
-
Posts
-
This is a set of parts for a design I am working on. They are printed from black T-Glas. The print took about 6 hours on fine mode. The spherical ball is .625 inches diameter instead of .635 inches, indicating about 1.6% shrinkage. Everything stayed well stuck to the bed. There is some flash to trim from the bottom layer. The threaded nut screws into its mating threads even though it is slightly small. This is one of my best prints so far, and is the fourth print from this machine.
https://www.dropbox.com/sh/r3ppu36im61kjsw/AAA7a_4vIkelvUvEMUWJhiuGa?dl=0
It is definitively quality I see with my Robox (with ABS). Maybe initial euphoria and too high expectations have subsided a bit and we learned to live with what we have. And I am not saying that’s bad or wrong or substandard.
Good calibration (and somehow I see you with couple of other people who post here are leading in it) help printed objects being quite correct. Please do continue to post your prints - they are definitively inspirational!
You must be logged in to reply to this topic.