This topic contains 1 reply, has 2 voices, and was last updated by 
BHudson 2 days, 19 hours ago.
-
Posts
-
Hi
Im wondering, can print warp like this when it cools down or do i have something wrong with my printer?
Higher it goes more mofe off it is in Y-axis. Printed with PETG 85% fill.
@poju In general, higher infill increases the chance to warp. I would also not orient the part like that as you are using a lot of support material and you also have a lot of acute angles on the edges, which lead to more chance of warping. I would print the part flat on the bed with a brim.
I operate two Betas and four Production Robox.
I am the US/Canada Technical Support engineer for the Robox.
See my 3D Hub site at https://www.3dhubs.com/phoenix/hubs/ben
You must be logged in to reply to this topic.
