Topic: Is the Octoprint supported?

RoboxDual › Forums › Technical Support › Is the Octoprint supported?

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Pete Pete 3 years ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 27/03/2014 at 7:48 am #2138

    YoungJae Chang @elite1111cyj

    I’m going to buy a Robox for my project.

    But I’m not sure if the Robox support the Octoprint.

    Octoprint said “If Robox runs either Marlin, Repetier or Sprinter as firmware, it should. If it runs something closed source, sorry, no idea.”

    Is the Robox runs Marlin, Repetier or Sprinter?

    28/03/2014 at 1:09 pm #2188
    Profile photo of Pete
    Pete @pete
    My Robox is a Blue Commercial Version
    CEL HQ Bristol UK

    Hello,

    We use a modified version of Slic3r.org which is open source. We control it with AutoMaker which is our software and is not open source.
    There will be an update later today about software via Kickstarter, I’ll put a link in the forum too.


    For official support please visit www.cel-robox.com/support/ and create a ticket

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.