This topic contains 2 replies, has 2 voices, and was last updated by Steve H 5 months, 2 weeks ago.
-
Posts
-
My youngest is now getting pocket money and needed a piggy bank, so I decided to print him one. I found a few designs on Thingiverse and he decided on this Bulbasaur one. Just for the hell of it (and after watching a youtube video on it recently) I thought I’d try it first in spiral print mode. It turned out better than I expected given the inherent unsuitability of the design, and it also made me realise that after scaling the design (to 75%) to fit the build volume the coin slot and hole were too small. I modified it slightly and printed it out again in draft profile with a good result. Filament is colorFabb nGen in dark green.
- This topic was modified 5 months, 2 weeks ago by Steve H.
Is the second (final) print spiral as well?
No, it’s just draft mode, no raft or supports.
You must be logged in to reply to this topic.
