Wellander
-
Wellander started the topic The print pauses for no reason in the forum Technical Support 5 months ago
Well no obvious reason.
The print head temperature - check 198
Bed - check 64
Layer 10/67
Remaining 00:14
Runnig laterst software.
I’ts been doing this the last few times. And it ends up clogging the head. I’ve been taking it apart more than once.
If I pause I don’t get a quit symbol so I can’t abort eather.
Last thing (I havn’t…[Read more]
-
Wellander replied to the topic Laded filament not found as loaded in the forum Technical Support 6 months ago
I’m observing a strange thing with the printing cycle.
My print will pause at the very same place during printing for several minutes before proceeding with the print. for no obvious reason. print head is at the exact right temperature and there is just a very long pause. This may be the reason why my filament gets stuck in the print head. I had…[Read more]
-
Wellander replied to the topic Laded filament not found as loaded in the forum Technical Support 6 months, 1 week ago
Thanks I’m up and running again. 🙂
However. can someone please have a look at this model of a ladder. When I try to print it in draft mode it only makes one trip along the sides with the thin head, and on one side it barely eject any material. Second and third layer is only applied on the steps nothing on the sides.
If I run it medium fine it…[Read more]
-
Wellander started the topic Laded filament not found as loaded in the forum Technical Support 6 months, 1 week ago
I shut the prinder off without ejecting the filament. Now that I start it up again it say there is no filament loaded.
Can I override the software and force it to eject?
-
Wellander started the topic The fine nozzle prints 3 turns + 1/4 of a turn in the forum Technical Support 1 year, 9 months ago
Printing PLA the fine noozle doing the outer pass prints the three cycles to create the outer surface but at the end of the third pass it goes back for 1/4th of a turn and adds to much material on that part of the model.
Is that normal?
-
Wellander started the topic the testlab in the forum Show us your bits! 1 year, 10 months ago
Here are my first prints.
Models made by me in zbrush. The dragon head is really small (30mm) with “fine” settings.
The toon head is bigger but with “normal” settings
-
Wellander started the topic How do I create custom profiles for 3rd party filaments? in the forum Technical Support 1 year, 10 months ago
I have found the “choose material”/”create new material” but it doesn’t seem to save to make the settings available in the drop down list.
How do I create a profile for a reel that is not Robox?
-
Wellander replied to the topic Units out there working as intended? in the forum Chatter 1 year, 11 months ago
wellmeadow: I had that same experience last night. After about 1 hour of good printing the filament stopped but the head kept working.
I aborted the job and did some maintenance. Starting a new job everything heated up as expected and it cleaned its nozzles fine but after that almost no filament at all once it should start the printing. So I…[Read more]
-
Wellander became a registered member 1 year, 11 months ago
