Chris

Walked into this again this morning…….Arrggggggggghhhhhhh.

Its only been happening since the new release of automaker. the parts are being shaken off the bed by the violent movements of the bed.

I’ve checked nothing is snagging them its just the violent bashing back and forward.

I’ve now rolled automaker back.

picture wont- up load - I…[Read more]

Walked into this again this morning…….Arrggggggggghhhhhhh.

Its only been happening since the new release of automaker. the parts are being shaken off the bed by the violent movements of the bed.

I’ve checked nothing is snagging them its just the violent bashing back and forward.

I’ve now rolled automaker back.

picture wont- up load - I…[Read more]

Walked into this again this morning…….Arrggggggggghhhhhhh.

Its only been happening since the new release of automaker. the parts are being shaken off the bed by the violent movements of the bed.

I’ve checked nothing is snagging them its just the violent bashing back and forward.

I’ve now rolled automaker back.

Chris

I know what you mean, but as everything ABS slides off my bed like water off a ducks back this is a 10000000% improvement on anything gone before. I’m going to try the open box torture test next.

Hi And welcome.

I am thinking you only have the single filament version. There is only one extruder driver in the case so pushing a second filament in slot 2 wont do anything unless you have the dual material kit fitted. (which also includes the extra reel holder). With the single material version the two nozzles on the head print the one…[Read more]

Hi Darren

I’ve found the raft works a lot better if you turn off the solid top layers in the profile (basically set to zero)

This means the contact between the model and the raft is reduced to only point contacts on the high spots created by the criss-crossing on the raft (i hope that makes sense.) An interface gap equivalent to the layer…[Read more]

Have you tried flipping it over?

There is a pause function that works perfectly well, Allows you to pause, take the excess material off and restart with minimal fuss. You will need to access the advanced functions to turn off the door safeties or slip a credit card under the door to unlock.

It might just be the PEI bed cover slipping. mine does it from time to time. You can bend the little metal tabs to hold it more securely (mentioned on here some where) but I’ve printed some little wedges that hold it in place as I’ve found bending the clips can give me problems with an uneven bed surface.

These are metal now on the Mk two heads. hopefully you can get one of them.

I really like the look of this material, I think I’ll have to try this once its out on the market.

Hi Alex

The instructions I had were to fit as normal and carry out a purge and a full 3 part calibration before use.

All went smoothly.

Chris

The web address seems to have come out a little odd - just copy and paste from the http to the html bit and ignore the rest.