Home › Forums › Software › Slic3r v1.2

This topic contains 0 replies, has 1 voice, and was last updated by Avatar of Clicky Clicky 6 days, 16 hours ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 16/11/2014 at 3:43 pm #9634

    Clicky @clicky

    Just to let you know that I swapped Sli3r v1.1.7, which was straight drop on replacement for v1.1.5 that came with AM with Slic3r v1.2 (experimental) and it works perfectly well for Mac. At least I did one object sliced - XY_resonance_test.stl from Make Magazine test.

    Important thing to know is that it doesn’t work on its own. You need to replace Slic3r.app dir with v1.2 and then *start* the Slic3r app itself. It will, in turn, display some info message about bed shape. After that, following start ups of Slic3r will not display anything else and will work with AutoMaker.

    I’m just printing missing part of the test (par nobody printed fully yet) and will report in Make Magazine topic…

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.